ENKO S.A.

Manufacturer of equipment for sewage treatment plants

Aerating turbines TNE

Aeration turbines are designed to aerate and put into motion a mixture of sewage and activated sludge in SBR technology.

Our products

A leading manufacturer of electromagnetic flow meters in Poland.

OSA

The only system on the Polish market for measuring the amount of collected sewage installed on a slurry tanker. It enables a real measurement of the amount of sewage collected.

Waste water disposal stations type STZ

New versions of process control and visualization, communication interfaces: RS 485, Modbus, Profibus, GPRS, Wi-Fi

ENKO S.A.

Manufacturer of equipment for sewage treatment plants

Sand separator with washing WPP in the new WashMem version

Sand separation, washing and dewatering - three functions in one device. Greater reduction of TOC pollution <2.8%.

Sand separator with washing type WPP

The washer-separator allows for effective sand separation and washing process.
The device is made entirely of stainless steel. The outer mantle is a cylindrical (active) surface, while the bottom - conical. The inlet pipe connects to the inner ring, and the outlet pipe connects to the surface of the outer casing.


In the lower part of the sand trap there is a "drop chamber" in which the pulp accumulates. Sand separation takes place thanks to the appropriate shaping of the inlet part to the separator, which causes a vortex stream flow. Separation of the organic fraction from the mineral is supported by an installed agitator. The oblique shaft-screw conveyor discharges the sand pulp to the container. In the sand trap, the mineral parts are dehydrated by gravity. The content of organic parts in the washed sand is up to 3%, and the degree of sand dehydration is 85 - 90% DM. Efficiency depending on the size of the device (of washed sand) 1,0 - 1,5 m3/h

 

   

Selected technical parameters:

 

  

WPP 30

WPP 60

WPP 90
efficiency m3/h 30 60 90
total length mm 4650 5450 5600
total height mm 2760 3000 3000
total width mm 1800 2100 3000
inlet nominal diameter mm 150 150 150
outflow nominal diameter mm 200 200 200
nominal water rinse diameter mm 25 25 25
drain nominal diameter  mm 100 100 100
spiral nominal diameter mm 200 200 200
auger motor power
carrying sand
 kW 1,1 1,1 1,1

agitator motor power

 kW

0,55

 0,55 0,55
material execution
devices
   stainless steel stainless steel stainless steel
options   heating, Ex version, rinsing control, pump control, communication interfaces: RS 485 Modbus RTU, Profibus DP, voltage free contacts (operation / failure)